Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bumping text
#8
(11-17-2019, 09:28 PM)Ofnuts Wrote: The black-white transitions are bound to cause problems, you should blur the bump-map a bit. We could try things if you also provide the "flat" initial layer.

Thanks, but I am thinking that my last post does the trick, unless my sight is deceiving me--shall know better tomorrow, looking under natural light.
I didn't blur more my 'aux' layer because I was trying to keep sharp angles sharp--there is a rounding in the center of the W which I raher dislike. But I tried for the same effect by stroking an 'inset path' and the rounding was much worse. 
All in all, I think that bumping gives the best result, and I rather like the effect of bumping twice, with some 45º of difference between each pass...
Anyway, I have attached the 'to bend' last path--once bent, it requires a very little editing of the right tip of the L--couldn't figure it before bending.


Attached Files
.zip   Tragedy0_AtLaw.zip (Size: 1.63 KB / Downloads: 3)
Reply


Messages In This Thread
Bumping text - by carmen - 11-17-2019, 03:50 PM
RE: Bumping text - by rich2005 - 11-17-2019, 04:43 PM
RE: Bumping text - by carmen - 11-17-2019, 05:45 PM
RE: Bumping text - by rich2005 - 11-17-2019, 06:15 PM
RE: Bumping text - by Blighty - 11-17-2019, 06:22 PM
RE: Bumping text - by carmen - 11-17-2019, 08:41 PM
RE: Bumping text - by Ofnuts - 11-17-2019, 09:28 PM
RE: Bumping text - by carmen - 11-17-2019, 10:13 PM

Forum Jump: