11-21-2018, 04:13 PM
11-21-2018, 05:47 PM
This is really going to depend on how artistic you are. Can you draw everything from scratch?
I am no artist, so I might go this route.
1. Find/make a brick wall. I used a tilable pattern but a photograph of an actual brick might work.
example https://i.imgur.com/HECEWfb.jpg
2. To add some realism, add some perspective. The Gimp 2.10 unified transform tool works very well. When that is set up cut out a hole in the wall.
https://i.imgur.com/3NjSSuu.jpg
3. Give it some depth, paint in ends of bricks, give them a bit of shading.
https://i.imgur.com/mdQvG8L.jpg
4. When thatis done add your hand. I found a superman fist that was easy to cut out very quickly but I think finding a suitable hand with some perspective might be difficult. Back to how good an artist are you.
https://i.imgur.com/iu9Ew4S.jpg
best of luck.
I am no artist, so I might go this route.
1. Find/make a brick wall. I used a tilable pattern but a photograph of an actual brick might work.
example https://i.imgur.com/HECEWfb.jpg
2. To add some realism, add some perspective. The Gimp 2.10 unified transform tool works very well. When that is set up cut out a hole in the wall.
https://i.imgur.com/3NjSSuu.jpg
3. Give it some depth, paint in ends of bricks, give them a bit of shading.
https://i.imgur.com/mdQvG8L.jpg
4. When thatis done add your hand. I found a superman fist that was easy to cut out very quickly but I think finding a suitable hand with some perspective might be difficult. Back to how good an artist are you.
https://i.imgur.com/iu9Ew4S.jpg
best of luck.
11-21-2018, 06:12 PM
I' want to try to replicate the look of this sculpture with digital images.
roger901
roger901
11-21-2018, 07:15 PM
Not too difficult at all.
1) Have an image with 2 layers. Wall is lower layer. Figure is upper layer. Like this:
https://imgur.com/a/xN7tdGo
2) On the upper (figure) layer, create a Layer Mask and accept the default white.
3) With the Layer Mask active, paint with black to hide parts of the figure. If you make a mistake, no problem, just paint with white to re-expose parts of the figure.
https://imgur.com/a/DFDZNDP
As Rich said, requires some artistic talent.
1) Have an image with 2 layers. Wall is lower layer. Figure is upper layer. Like this:
https://imgur.com/a/xN7tdGo
2) On the upper (figure) layer, create a Layer Mask and accept the default white.
3) With the Layer Mask active, paint with black to hide parts of the figure. If you make a mistake, no problem, just paint with white to re-expose parts of the figure.
https://imgur.com/a/DFDZNDP
As Rich said, requires some artistic talent.
11-21-2018, 10:42 PM
Great...thanx guys.
roger901
roger901