I have a design which must be printed to fit in a 36" circle. I must print on separate pieces of 8x10" paper to transfer the image for the final design. How can I do this? I tried making pie-shaped sections but that does not come out correctly . I appreciate any help.
Thank You
Dave
Cut you image into several sub-images, that each fit on a 8"x10" sheet. Remember that you print likely has margins (there is almost at least one at the bottom of the sheet).
OTOH the image you show looks very pixellated... and 36"" at a decent print definition (150PPI) is quite big (5400x5400px). This would be better done with vector graphics (i.e., InkScape).
FWIW: A quick redraw in Inkscape as a vector. Not exact but close, maybe someone can improve it. (attached)
Just a note, normally avoid real world units (inches) like the plague, Gimp works in pixels, however in this case...
For that size I would say 150 ppi is ok. A slightly larger canvas for working room 40'' x 40 '' @ 150 ppi is 6000 x 6000 pix
Import a svg vector like this:
https://i.imgur.com/K0a0rh7.jpg
Then for dividing it up I would make a selection say 10'' x 8'' and move it around. There is a mode in the move tool for selections. Guides can be added using
Image -> Guides -> New Guides from selection https://i.imgur.com/Jyc0Qpa.jpg
and eventually that large image split up into printable sizes using
Image -> Slice using Guides.
All a bit sketchy but it is time to pack in for the day.
Just a couple of thoughts.
It is symmetrical so you only need half. That will reduce memory requirements for the computer
there is an program to divide up for printing see:
https://posterazor.sourceforge.io/
(02-27-2020, 07:50 AM)rich2005 Wrote: [ -> ]It is symmetrical so you only need half. That will reduce memory requirements for the computer
Yes, but not a bilateral symmetry due to colors, so unless you have a good technique to splice things rotated by 72° you can't take advantage of it.
(02-27-2020, 09:30 PM)Ofnuts Wrote: [ -> ] (02-27-2020, 07:50 AM)rich2005 Wrote: [ -> ]It is symmetrical so you only need half. That will reduce memory requirements for the computer
Yes, but not a bilateral symmetry due to colors, so unless you have a good technique to splice things rotated by 72° you can't take advantage of it.
Yes, you are of course correct. Lots of fiddling required. Not practical.