Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to get paint tool to stop at selection borders
#1
Hello,

Please have a look at the following screen shot:

[img]http://www.shahspace.com/before painting elvis's tail.png[/img]


I prepared the selection so that I could click the paint tool between the two wavy lines and have it fill only between those lines.

But this is what happened:

[img]http://www.shahspace.com/after painting elvis's tail.png[/img]

Not only did it paint between the lines, but outside as well.

I was expecting the paint tool to propagate from the point where I clicked until it hit borders, those borders being both the lines I drew an the borders of the selection. It seem it did stop painting beyond the selection border, but then continued propagating until it got to the region outside the lines inside the selection, and then started painting again.

How do I configure the paint to stop propagating once it hits selection borders as well as lines drawn in the layer?

Thanks.
Reply


Messages In This Thread
How to get paint tool to stop at selection borders - by gib65 - 01-05-2018, 07:54 PM

Forum Jump: