Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
creating a pseudo 3d wireframe globe
#4
(08-07-2019, 12:59 PM)Blighty Wrote: Use guides. When adding the guides precise measurements can be used. Make sure "Snap to Guides" is turned on.

The straight lines can be added with the paintbrush. For a straight line first Click, then Shift-Ctrl Click.

For the circle, create a selection and stroke the selection. Better still, create a path and stroke the path as this gives better results.

For the ellipse you can scale the circle selection (or path) to give an ellipse and stroke that. Or create a new selection (or path) from scratch.

Put each element (circle, ellipse, line) on its own layer. Makes things much easier if editing is needed.

For that type of image vector graphics is better (Inkscape).

just out of interest how did you place the guidelines to the exact equal places? I tried to do it based on calculations by adding and dividing and using percentages but the final result seems like its not symmetrical and this process probably wasn't the most efficient.
Reply


Messages In This Thread
RE: creating a pseudo 3d wireframe globe - by musicandart2080 - 08-07-2019, 05:11 PM

Forum Jump: