10-05-2019, 07:29 PM
Did this while you were updating Gimp 
You will find Gimp 2.10 much easier to use in a lot of ways.
Best guess, you have an active selection and the bit you want to blur is outside the selection. (1) not in the selection (2) inside the selection. Try inverting the selection.
You will find Gimp 2.10 much easier to use in a lot of ways.Best guess, you have an active selection and the bit you want to blur is outside the selection. (1) not in the selection (2) inside the selection. Try inverting the selection.