01-19-2021, 01:22 PM
I tried to reproduce the example given in post #7 in order to learn about this 'new member', but I got an unexpected result.
In the image below you can see in blue the desired circle and its radius (in red), as well as the information in the 'Error console' window about the size of that diameter (300). It is also visible that there is still part of the 'truchet' that should have been removed.
By inverting and selecting the inner part, the result also shows an 'excess' (which was expected to have been cut)
In the image below you can see in blue the desired circle and its radius (in red), as well as the information in the 'Error console' window about the size of that diameter (300). It is also visible that there is still part of the 'truchet' that should have been removed.
By inverting and selecting the inner part, the result also shows an 'excess' (which was expected to have been cut)