Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Batch Image Processing (layer manupulation)
#1
Hi,

I'm kind of new using batch processing. I have about 300 pages of scanned old manuscript. Its yellowish and stained.

Normally I will clean it up by:


1. Duplicate the layer
2. Change the top layer mode to "grain merge"
3. Merge down the layer.
4. Repeat the steps until I got a much cleaner page.
5. Touch up using brush.

I was wondering if there is a scrip or command that I can use to to step 1 to step 3 on batch file. I mean, cleaning up old manuscript for family safekeeping is really hard work. If there is a batch processing that I can run and sit back. I still need to touch up here and there of course, but this will take at least 75% work load if I can automate it.

Thank you
Reply


Messages In This Thread
Batch Image Processing (layer manupulation) - by izwan - 11-23-2021, 01:02 PM

Forum Jump: