Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tape damage restoration help
#5
OK, you were speaking about those white spots all around, am I right?
If so, it might be easier in attenuating them  Big Grin

I give you three methods which work very differently for "different" purpose, even though the two later are very similar using the same filter but for a very different purpose.

1) For the small spots and selected area, I'll make a selection and go with the Filters ➤ Distorts ➤ Value Propagate... (select More Black for darker area and select More white for whiter/brighter area like hands)
   

2) Still using a selection on small spotted areas, this is another option
Make a selection go to Filters ➤ Blur ➤ Median Blur...
   

3) This time it's for the whole picture (works with area/selection as well)
Duplicate your photo, on the top duplicated photo, go to Filters ➤ Blur ➤ Median Blur... BUT this time put the mode in Subtract mode => you will got a black image with some white spots parsed,
   

you will need to increase the brightness a bit I'll do it with Colors ➤ Curves...
   

Once it's done put that top black layer in Subtract Mode (yes in the filter and now in the layer's stack Wink )
   

Hope this can shorten your work.
Reply


Messages In This Thread
Tape damage restoration help - by Bhang - 07-27-2022, 02:02 AM
RE: Tape damage restoration help - by PixLab - 07-27-2022, 03:23 AM
RE: Tape damage restoration help - by denzjos - 07-27-2022, 07:09 AM
RE: Tape damage restoration help - by Bhang - 07-28-2022, 01:22 PM
RE: Tape damage restoration help - by PixLab - 07-29-2022, 04:58 AM

Forum Jump: