Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Batch Image Manipulator & Curves Script
#4
A bit of a struggle to locate the problem.

I can not see any problem with the command you posted. Sometimes, there is a stray character right at the end, That happened to me before, check that, but the problem is...

It is a Windows / QT thing. That 'other-gimp-procedure' does not work with the Windows G'mic-QT plugin. (linux is ok)

However, it does work with the GTK version, so if you can be bothered, install that one as well. AFAIK it does co-exist with the GTK version (at least it does in Linux).

In a Win 10 VM, looks like this. https://i.imgur.com/4IOWkh6.jpg Also attached the saved .bimp script in the zip file.

Your curve lightens the image a little.

An alternative, again has to use gmic_gimp_gtk plugin is the gmic script gmic_shell.scm
 
You can insert exactly the same command in that script (line 23). Check it on open image if you need. it is at bottom of the filters menu. If you try this, I advise getting a better text editor than notepad. Notepad++ is free and will not screw the formatting up. Script is in the zip.

In BIMP it shows up like this: https://i.imgur.com/SKIM3BB.jpg

Just a note: No search facility in gmic_gimp_gtk  The curve filter is down in Testing -> Ronounours -> Curves


Attached Files
.zip   bimp-plus-shell.zip (Size: 1,020 bytes / Downloads: 195)
Reply


Messages In This Thread
RE: Batch Image Manipulator & Curves Script - by rich2005 - 11-12-2017, 10:44 AM

Forum Jump: