Grid does not align with ruler.

[rich2005]

(11-11-2017, 10:16 PM)Tenderfoot Wrote: Many thanks for your quick and helpful replies.
I had never noticed the Advanced Options in the Create New Image Drop down, nor had I realised that the number of pixels per inch made a difference to what I see on screen. Why does it default to a low number when 'bigger is better' ?   Is it just a memory issue?

Traditionally, it is 72 pixels-per-inch ppi (aka dots-per-inch dpi) And that dates back to CRT monitors where that was the scan resolution. Fine for Web Graphics, not so good for printing. If you look at the default templates 'A' series, USletter, these are 300 ppi, generally rule-of-thumb for photo-quality 300 ppi. PPI (dpi) is also the traditional units for printers, so I suggest 254 just on the basis it is mm-to-inch conversion, and that will print ok

Quote:To explain what I'm trying to do:
I'm wondering if GIMP can be used to design small electronics circuit boards quickly and easily. Many components pins are based on a 1/10 inch grid. By using the GIMP grid set to 0.1 and 'snap to grid' it looks like it might work well enough if I set a high-ish pixels/inch.

When it comes to your project. Gimp not really the best tool. I would go for a CAD application, maybe LibreCAD which is free followed by maybe Inkscape, a vector drawing application.

"quickly and easily" using Gimp - ouch, Probably need to design your own brushes which can be used as a 'stamp' Can be sized and rotated. But it is going to be tedious.

example: (I am civ-eng, not electrical ) oops, had to change the screenshot, not a schematic, a circuit. That might be a little easier. Still need to make some brushes.