Hi All.
I am pretty new at GIMP, but trying to learn.
The image below is made in Autodesk Inventor and i am trying to illustrate Foam
getting injected from a doorway sanitiser to the floor.
What function could i use to make the foam look somewhat realistic?
I have not been able to find any tutorials on that particular subject.
Thank you in advance
Using Gimp is going to be very hands-on. First find a pattern that suits (not too easy these days where everything has a watermark over printed)
That can fill a selection of the required shape. But then to give a bit of depth, paint around the edges, Use a clip-board brush copied from the pattern.
One thing about the image. Not much in the way of lighting. Needed to give some representation of depth. The only indication is a small shadow on the blue wall box. Put in a weak drop shadow in that direction.
Without spending too much time on it.
[
attachment=4406]
Have you tried Blender ? That is 3D and there might be a fog or mist or droplet filter that works.
(05-19-2020, 01:22 PM)rich2005 Wrote: [ -> ]Using Gimp is going to be very hands-on. First find a pattern that suits (not too easy these days where everything has a watermark over printed)
That can fill a selection of the required shape. But then to give a bit of depth, paint around the edges, Use a clip-board brush copied from the pattern.
One thing about the image. Not much in the way of lighting. Needed to give some representation of depth. The only indication is a small shadow on the blue wall box. Put in a weak drop shadow in that direction.
Without spending too much time on it.
Have you tried Blender ? That is 3D and there might be a fog or mist or droplet filter that works.
Thank you very much.
I will give it a try
I have been playing around with 3DS MAX and it is very impressive, BUT......everything i import from Inventor i have to put new materials on.
It is way to time consuming.
Blender is simular, right?