12-14-2022, 09:22 PM
(12-14-2022, 08:20 PM)koopdi Wrote: By the way, what are those arrows for on the rulers?
The instructions only say to measure the rulers.
Am I supposed to set the arrows to a pixel value and enter the length of that pixel count?
Or do I enter the length of the entire ruler?
I am not sure what those arrows do.
That screenshot was a Gimp 2.99.14 and not very clear. This is a better one. In the past I just measure the whole length with a ruler, inch or metric, set the units accordingly.
You can give it a try but probably just give the same as you already have.