Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Getting Liquid Rescale to work on Gimp 2.10.18 revision 2
#1
This workaround was done in Windows 10, and would have to be verified for other OS.

I found a way of getting liquid rescale to work on 2.10.18 revision 2 in Windows 10. It's a workaround, and since it requires a "dirty" install I don't really like it. However, until in works normally I'm doing it this way.
  • Assuming we're starting with a clean install, first install Gimp 2.10.14 revision 3 (gimp-2.10.14-setup-3)
  • Second, copy the liquid rescale plugin files, inside their own folder, to the plug-ins folder (If installed for all of users it's usually C:\Program Files\GIMP 2\lib\gimp\2.0\plug-ins  OR  if installed for a single user it's usually C:\Users\username\AppData\Local\Programs\GIMP 2\lib\gimp\2.0\plug-ins )
  • Third, run Gimp so that it loads the plugin.
  • Fourth, install Gimp 2.10.18 revision 2 (gimp-2.10.18-setup-2) over the 2.10.14 rev 3 installation. In other words, don't uninstall the previous version (don't perform a clean install). DO NOT RUN GIMP YET.
  • From here there are various paths depending on how the installation was done:
  1. Wether Gimp was installed for all users, or just a single user, if the liquid rescale plugin files were copied into their own folder, then everything should be working fine.
  2. If Gimp was installed for a single user and the liquid rescale plugin files the plugin files were were not copied into their own folder, then you have to copy them again.  This is because, when we installed 2.10.18 rev 2 over the previous installation of 2.10.14 rev 3, the liquid rescale plugin DLL was deleted. If you run Gimp before recopying the files an error will pop-up and the plug-in will no longer be recognized by Gimp. To fix it, you will need to do a clean reinstall from 2.10.14 rev 3.
  3. If Gimp was installed for all users and the liquid rescale plugin files the plugin files were were not copied into their own folder, then you have to copy them again.  This is because, when we installed 2.10.18 rev 2 over the previous installation of 2.10.14 rev 3, the liquid rescale plugin DLL was deleted. If you run Gimp before recopying the files the plugin will work. It will give an error saying the required DLL is missing. To fix it, just recopy the plugin files and restart Gimp.
Reply


Forum Jump: