ofn-bend-path error / help?

[eepjr24]

(11-26-2020, 12:43 PM)rich2005 Wrote: A different approach, might come in useful. 
This using only paths and Ottia Tuota's Path Transforms plugin see: https://www.gimp-forum.net/Thread-Path-transformations

Using this:



The plugin dialogue: Path shaped by a bezier arc



Gives this:



Remember, that arc is a 2-node path, no use making from a circular selection.

Well, even with the polar arc, I cheated and just did a 2/3 path, flipped, merged and edited. So if you use a repeating pattern it could easily get you to the right result still, correct? And it seems to be relatively simple to do.

Thanks all on this forum for being so interactive. The ofn-bend-path did not turn out to be what I needed this time but now I know what it does along with the ofn-path-edits and ofn-dial-marks. Plus now I have a lot more knowledge of strokes, paths, polar coordinates, and another new sets of plug-ins in my toolbox. Nice to see such a community, hopefully I can contribute back at some point.

- Ernie