V2.10.20
I meticulously followed this video. Wrote down every step
https://youtu.be/JW_siMWqnr4
and applied the technique to a couple of B&W.jpg images. Worked fine. Was able to apply skin tones, hair tone etc as in the video.
Today I try another couple B&Ws. I get as far as ready to paint the first layer (skin tone) but nothing happens. I wipe the brush over the image and it stubbornly stays B&W.
Went over the video again and over my notes. And redid from scratch again. No go.
I then reloaded one of the earlier xcf images that worked before (still unfinished)
Same thing. Paintbrush does nothing. Newly created palettes make no difference.
I re-installed GIMP just in case. Nope Same dead end.
Completely baffled!
W7 x64 8GB RAM
Marty
I meticulously followed this video. Wrote down every step
https://youtu.be/JW_siMWqnr4
and applied the technique to a couple of B&W.jpg images. Worked fine. Was able to apply skin tones, hair tone etc as in the video.
Today I try another couple B&Ws. I get as far as ready to paint the first layer (skin tone) but nothing happens. I wipe the brush over the image and it stubbornly stays B&W.
Went over the video again and over my notes. And redid from scratch again. No go.
I then reloaded one of the earlier xcf images that worked before (still unfinished)
Same thing. Paintbrush does nothing. Newly created palettes make no difference.
I re-installed GIMP just in case. Nope Same dead end.
Completely baffled!
W7 x64 8GB RAM
Marty