04-20-2024, 07:25 AM
I made my first path yesterday.
And exported the pic to a .jpg
All very well.
Opened the xcf today and there is all is, path and all.
I made the brush too wide. The path is too thick.
I want to make it narrower and perhaps move it a bit.
I've clicked paths/edit mode/design, then edit, then move and done no good with any of them. Can't make anything happen.
Then I've found the dockable dialog 'paths' but that hasn't helped.
My cursor remains as a cross above an arc and with a small crossed circle next to it.
How do make this path thinner and move a bit of it ?
And exported the pic to a .jpg
All very well.
Opened the xcf today and there is all is, path and all.
I made the brush too wide. The path is too thick.
I want to make it narrower and perhaps move it a bit.
I've clicked paths/edit mode/design, then edit, then move and done no good with any of them. Can't make anything happen.
Then I've found the dockable dialog 'paths' but that hasn't helped.
My cursor remains as a cross above an arc and with a small crossed circle next to it.
How do make this path thinner and move a bit of it ?