Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Extracting a "Dotted Network" skeleton from a glowing raster image for vector editing
#7
(8 hours ago)saint_m Wrote: g day rich  well  this is only a example nothing more. I did not find anything other - but i would say - there must be millions and much much more out there.

It is not a case of the image posted. The problem is your requests are not easily fulfilled using Gimp / Inkscape / Krita.

Just to get a mass of overlapping dots separated from a mass of half visible connecting lines to try and get a centerline trace out of Inkscape is almost impossible, needs a lot of preparation for a less-than wonderful result. - that was one of your requests.

You would be better off finding some other way.
Reply


Messages In This Thread
RE: Extracting a "Dotted Network" skeleton from a glowing raster image for vector editing - by rich2005 - 8 hours ago

Forum Jump: