Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ofn-engraving
#10
(06-13-2019, 06:59 AM)Ofnuts Wrote: I think that what happens is that your path is so "dense" that you get only one layer. In other words, stroking the path with your minimal line width already male tje resulting image darker than the maximum darkness. Can you confirm by setting the Result to Keep layers and counting the layers that have been created?

Edit: problem and cause confirmed: fix uploaded soon, in the mean time, don't do that Smile

I could not reproduce the same conditions again. Although you tried to use the same settings. With this I got only a new layer generated, with the mask layer totally white and the image very dark and dense.

I've never used it before with the Layers option, I thought there would be as many layers as the number of steps used by inbetweener-02, but there's no such correlation, and with those layers the filter gets even more interesting!

Apparently everything is okay, just do not create such a dense mesh.  Blush

Thx Ofnuts.
Reply


Messages In This Thread
ofn-engraving - by Ofnuts - 03-27-2019, 10:02 PM
RE: ofn-engraving - by Ofnuts - 03-28-2019, 11:07 AM
RE: ofn-engraving - by Krikor - 03-29-2019, 12:20 AM
RE: ofn-engraving - by Ofnuts - 03-29-2019, 07:01 AM
RE: ofn-engraving - by Krikor - 03-29-2019, 10:25 PM
RE: ofn-engraving - by Ofnuts - 06-10-2019, 01:52 PM
RE: ofn-engraving - by Krikor - 06-13-2019, 01:22 AM
RE: ofn-engraving - by Krikor - 06-13-2019, 02:30 AM
RE: ofn-engraving - by Ofnuts - 06-13-2019, 06:59 AM
RE: ofn-engraving - by Krikor - 06-13-2019, 10:05 PM
RE: ofn-engraving - by Ofnuts - 06-13-2019, 11:20 PM
RE: ofn-engraving - by Ofnuts - 06-14-2019, 02:28 PM
RE: ofn-engraving - by Krikor - 06-14-2019, 06:26 PM
RE: ofn-engraving - by Ofnuts - 06-14-2019, 09:05 PM
RE: ofn-engraving - by Ofnuts - 06-15-2019, 10:48 PM
RE: ofn-engraving - by Krikor - 06-16-2019, 11:51 PM

Forum Jump: