01-22-2020, 11:27 AM
Hi!
I migrated yesterday coworker's workflow from Linux to Windows and got big surprise, that in some cases Gimp (2.10.14) exports image upside down.
Our workflow follows:
* scan image upside down into TIFF
* open TIFF in Gimp
* rotate image 180 degrees
* crop image
* make needed improvements (levels, any corrections needed)
* scale image down
* export to original file/overwrite original file
After that we sometimes get image upside down, where all changes after rotating are fine. How is that possible? How to fix it?
The workflow under Linux was exactly same, but we never had such behavior.
TIA,
Gunnar
PS. I think, this topic is better suited to Gimp 2.10 subforum, but I don't see "Post Thread" button there.
I migrated yesterday coworker's workflow from Linux to Windows and got big surprise, that in some cases Gimp (2.10.14) exports image upside down.
Our workflow follows:
* scan image upside down into TIFF
* open TIFF in Gimp
* rotate image 180 degrees
* crop image
* make needed improvements (levels, any corrections needed)
* scale image down
* export to original file/overwrite original file
After that we sometimes get image upside down, where all changes after rotating are fine. How is that possible? How to fix it?
The workflow under Linux was exactly same, but we never had such behavior.
TIA,
Gunnar
PS. I think, this topic is better suited to Gimp 2.10 subforum, but I don't see "Post Thread" button there.