04-17-2021, 07:31 AM
(This post was last modified: 04-17-2021, 08:42 AM by rich2005.
Edit Reason: typo
)
As you found, you cannot selectively edit the Gimp 'undo' stack only go back to a specific point. The undo stack is not retained when you save then exit Gimp.
Do not rely on 'undo'. Adjust your work flow.
Save versions (name01.xcf , name02.xcf ...etc) as you go along
or
Create stages in your editing. You made some color balance adjustment. Use Layer -> `New from Visible' and continue.
Under that Layer is previous, above is new editing based on new-from-visible. Repeat as required.
Do not rely on 'undo'. Adjust your work flow.
Save versions (name01.xcf , name02.xcf ...etc) as you go along
or
Create stages in your editing. You made some color balance adjustment. Use Layer -> `New from Visible' and continue.
Under that Layer is previous, above is new editing based on new-from-visible. Repeat as required.