07-27-2021, 01:31 PM
from librecad the drawing size produced is far bigger than I need (thousand by thousand or more. I have at most 700 pixel wide space in my pages. But the jpg librecad exports is few thousand . So it is ok. I am just reducing the size of images to 700 pixel wide at most. But form my previous experience with amazon, if the dpi of a picture in pdf file was below 300, it gave error automatically and I remember going back and adjusting the dpi of those images to 300 and it had worked. That is my concern. Otherwise I am not also fond of adjusting ppi of a couple hundred images from 96 dpi to 300. . That is the only reason I am doing this. Are you saying I do not need to?