Gimp-Forum.net › GIMP › General questions
Almost able to print with GIMP

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Almost able to print with GIMP
PixLab Offline
Gimper extraordinaire
*****
Posts: 1,333
Threads: 55
Joined: May 2021
Reputation: 152
Operating system(s):
  • Linux

Gimp version: 2.10
#6
06-28-2022, 06:05 AM (This post was last modified: 06-28-2022, 06:06 AM by PixLab.)
I tried to explain that it is not because you cannot see it that it's not there or not actionable...
If it's just a visibility problem you could access it.
So, after "Center ➤ None" on your last screenshot try one more time the tab key, if nothing seems to be selected it's a good sign it means you might have selected something "below", then hit the space bar (to tick), and do a test print.
Find
Reply


Messages In This Thread
Almost able to print with GIMP - by ajax - 06-25-2022, 03:58 PM
RE: Almost able to print with GIMP - by rich2005 - 06-25-2022, 04:49 PM
RE: Almost able to print with GIMP - by ajax - 06-26-2022, 02:36 AM
RE: Almost able to print with GIMP - by PixLab - 06-26-2022, 03:32 AM
RE: Almost able to print with GIMP - by ajax - 06-27-2022, 07:47 PM
RE: Almost able to print with GIMP - by PixLab - 06-28-2022, 06:05 AM
RE: Almost able to print with GIMP - by ajax - 06-28-2022, 03:06 PM
RE: Almost able to print with GIMP - by PixLab - 06-29-2022, 03:24 AM
RE: Almost able to print with GIMP - by rich2005 - 06-28-2022, 07:18 AM
RE: Almost able to print with GIMP - by ajax - 06-29-2022, 01:33 AM
RE: Almost able to print with GIMP - by Punchcard - 03-19-2023, 05:41 PM

Forum Jump: