08-05-2018, 06:06 PM
To be honest I dont quite understand what the script is saying. What I have done is this.
I created an ellipse circle, I used path to selection to create a path. I then used a guide marker to where I want to start the path within the circle. I then used the path tool to go around the top bit of the ellipse circle until i got to the othe end. I then pressed enter and removed the bottom of the ellipse circle.. If you check the attachment I am now left with a load of dots than isnt a path but could well be a path if i connect them.
I'm ever so confused..
I created an ellipse circle, I used path to selection to create a path. I then used a guide marker to where I want to start the path within the circle. I then used the path tool to go around the top bit of the ellipse circle until i got to the othe end. I then pressed enter and removed the bottom of the ellipse circle.. If you check the attachment I am now left with a load of dots than isnt a path but could well be a path if i connect them.
I'm ever so confused..