Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New user needs Assistance
#4
(01-13-2021, 10:10 PM)Mac101 Wrote: Hi , I am new here.

I have a problem .
I have a service manual that has a total of a 104 pages.  (A4, jpg)

One complete section is 8 pages . 4 on the top row and 4 on the bottom row.
to make one complete sheet .
They were scanned and sent to me .
Now to be able to use them I have to stitch them back together it a full large pages .

each Page was scanned as a jpg and they had a very dark back ground that I managed to clean up
using auto Balance .
I have look though the help and could not figure out How to increase the work space to fit four A4 sheets on
top . and Two A4 down . 8 sheets  to make one complete  image  . so I can put this jigsaw back together .
Also some of the pages are not 100% square so the alignment will have to be slid over to match ..
Is this possible .
If so How in the simplest way possible .

O forgot I am using Linux and version 2.10.18
Thanks
The SAVE AS does not give the options to save as a PDF .JPG or any thing other than a XCF
so I cant open the images in an other program . is there a way of saving as a image or PDF etc
Thanks
Reply


Messages In This Thread
New user needs Assistance - by Mac101 - 01-13-2021, 10:10 PM
RE: New user needs Assistance - by Ofnuts - 01-14-2021, 07:28 AM
RE: New user needs Assistance - by Mac101 - 01-14-2021, 08:19 PM
RE: New user needs Assistance - by Mac101 - 01-14-2021, 11:09 PM
RE: New user needs Assistance - by rickk - 01-15-2021, 03:48 AM
RE: New user needs Assistance - by Mac101 - 01-15-2021, 05:39 PM
RE: New user needs Assistance - by rickk - 01-15-2021, 06:03 PM
RE: New user needs Assistance - by Ofnuts - 01-15-2021, 09:56 AM
RE: New user needs Assistance - by Mac101 - 01-14-2021, 10:48 PM
RE: New user needs Assistance - by Ofnuts - 01-14-2021, 11:08 PM
RE: New user needs Assistance - by Mac101 - 01-15-2021, 07:14 PM
RE: New user needs Assistance - by rickk - 01-15-2021, 09:56 PM
RE: New user needs Assistance - by Mac101 - 01-15-2021, 11:03 PM

Forum Jump: