Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Working with Paths
#6
As described by Blighty, all depends on the path tool mode. In particular look out for the cursor symbol, +

   

struggled to get that less than 500KB Smile

edit: ctrl-z (undo) is your friend here. Accidentally create a node? back off that click.
Reply


Messages In This Thread
Working with Paths - by Blighty - 10-31-2016, 08:44 AM
RE: Working with Paths - by rich2005 - 10-31-2016, 11:11 AM
RE: Working with Paths - by eingram25 - 03-18-2017, 03:37 PM
RE: Working with Paths - by sallyanne - 11-02-2016, 04:45 AM
RE: Working with Paths - by Ofnuts - 11-02-2016, 07:53 AM
RE: Working with Paths - by Blighty - 11-02-2016, 08:10 AM
RE: Working with Paths - by rich2005 - 11-02-2016, 08:52 AM
RE: Working with Paths - by Ofnuts - 11-02-2016, 09:49 AM
RE: Working with Paths - by sallyanne - 11-02-2016, 09:40 AM
RE: Working with Paths - by Espermaschine - 11-02-2016, 05:15 PM
RE: Working with Paths - by Ofnuts - 11-02-2016, 05:28 PM
RE: Working with Paths - by Espermaschine - 11-03-2016, 12:39 AM
RE: Working with Paths - by Ofnuts - 11-03-2016, 01:06 AM
RE: Working with Paths - by rich2005 - 03-18-2017, 04:50 PM
RE: Working with Paths - by eingram25 - 03-19-2017, 01:57 AM
RE: Working with Paths - by rich2005 - 03-19-2017, 08:28 AM
RE: Working with Paths - by eingram25 - 03-19-2017, 12:41 PM
RE: Working with Paths - by rich2005 - 03-19-2017, 01:22 PM

Forum Jump: