Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
removing fold shadow / highlight from a scan
#10
(01-03-2021, 09:01 AM)Ofnuts Wrote: Actually I use a better technique now:
  • Filters>Enhance>Wavelet decompose
  • On the Residual channel: "Filter>Blur>Pixelize" and pixelize to its size to average it.
You can also at the same time duplicate the top layers to increase sharpness/contrast of text.

I guess I am just too old to grasp some essential as the two dot points produced nothing but a fuzzy mess.  Presumably I am missing some blindingly obvious next step.

I did not do the third step as I wanted to see how it looked before and after
Reply


Messages In This Thread
RE: removing fold shadow / highlight from a scan - by The ancient one - 01-05-2021, 08:22 AM

Forum Jump: